Aircraft List
COLD START (ROLEPLAY)
Throttle
Microphone button
Connect Ground Electric Power
Instruments Panel
ALTERNATE lamp
On
Instruments Panel
Pressure Gauge Selector Switch
ALTERNATE
Instruments Panel
Hydraulic pressure gauge
Approximately 3000 PSI
Instruments Panel
Landing gear control lever
EXTENDED (down)
Throttle Quadrant
Throttle
Off
Right Forward Console
ENGINE MASTER switch
On
Right Forward Console
BATTERY-OFF-STARTER switch
STARTER
then
BATTERY
Instrument Panel & Throttle Quadrant
Tachometer & Throttle
At
3% engine rpm,
set throttle control to
THROTTLE OUTBOARD
position
Instrument Panel & Throttle Quadrant
Tachometer & Throttle
At
6% engine rpm,
move throttle control to
IDLE
position
Instrument Panel
Exhaust Temperature Gauge & Fuel Flow Meter
As the engine spools to idle, check that the temperature is between
600 - 690°C
and
that the fuel consumption does not exceed
500 – 800 pounds per hour.
Instrument Panel
Generator warning light
Off
at 58% engine rpm
Throttle
Microphone button
Disconnect Ground Electric Power
Throttle Quadrant
Throttle
IDLE
Instrument Panel
Hydraulic pressure gauge selector
NORMAL
Left Aft Console
Flight Control switch
Set to
RESET
than when
alternate-on warning light is out
, set to
NORMAL
Flight Controls
Stick & Pedals
Move the controls
in all directions and visually
check
for proper control surface movement.
Once the control stick is brought to the
neutral position
, the pressure should be between
2750-3200 PSI.
Left Aft Console
Flight Control switch
ALTERNATE ON
Instrument Panel
Hydraulic pressure gauge selector
ALTERNATE
Flight Controls
Stick & Pedals
Move the controls
in all directions and visually
check
for proper control surface movement.
Once the control stick is brought to the
neutral position
, the pressure should be between
2750-3200 PSI.
Left Aft Console
Flight Control switch
Set to
RESET
than
NORMAL
Instrument Panel
Hydraulic pressure gauge selector
UTILITY
Throttle
Speed brake switch
Extend and retract speed brakes
Instrument Panel
Hydraulic pressure gauge
Approximately 3000 PSI
Instrument Panel
Hydraulic pressure gauge selector
NORMAL
Throttle Quadrant & Instrument Panel
Throttle & Voltmeter
Set
the engine speed to
45% rpm
and
check
the voltmeter readings which should show
approximately 28.5V
Back to checklist selection
Developed by
Santus